Seat Pan

Since I am so incredibly close to driving this around, the seats are getting a lot of attention. The seat pans have been finished as have the wood bases. The bases have been cut from 7 ply 3/8" Baltic Birch plywood. So you are viewing first, the plywood base, then the metal pan, then both together setting in the chrome seat bottom.  I'm going to put a wood sealer on the plwwood, then they get fastened together.  This was done originally with small nails.  I think that I will see if I can use a small screw so I don't have to hammer on the paint.

Finally, the last shot is of the three good metal bent plates after primer.