Wednesday, June 16, 2010
Cleaned up rear axle brake drums. Other shots are of each side axle hub and brake backer plate. I have to pull the axles as the
wheel lugs are stripped out on the right side. They are essentially hamered over onto the hub similar to a rivet. They will need to be drilled out when the axle is removed and new installed. Getting the whole assembly sandblasted prior to disassembly sounds cleaner and easier. The differenial oil seal is so shot that I have drained all the oil (sorta like oil) by turning the diff down.
Saturday, June 12, 2010
Some more cleaned bits of the front suspension
. Notice the stub axle on the upper right. It apparently got so hot that it turned black and shows tracks as if it was throwing welding sparks. Obviously, will be replaced. All the rubber bushes have been removed and discarded. I am trying to decide if they should be replaced with polyurethane rather than rubber. They are stiffer and last longer and will give sharper handling but also give a harsher ride. Second photo shows the recoated front sway bar and torsion bars. Then the two front hubs; the right front grease was hard as wood. Maybe a result of the overheated stub axle? Or the cause?


Cleaned
up the chicken crap welding on the left frame motor mount. Needs to be rewelded as the weld was brittle and full of holes. Other shots are of lots of bits and pieces from the front suspesion. Sandblaster has been busy. Most are cleaned and ready to be paint-preped and finally painted. Ordered some epoxy paint for the cast iron bits to experiment with on the color
.

I started to disassemble
the rear axle. Discovered that the brakes had been recently redone. If you look closely you can see the rivets that attach the shoe lining are still shiny and bright. The drums were turned properly. Looks good. The inside and of the drum was painted chrome/aluminum. Clean but not original. The differential seal is completely shot and allowing something that should be oil to escape. When the leaf springs came off, it was apparent that the wedge spacer that sets betwen the axle and the spring on the right side was installed in the wrong place ( about a quarter inch out) at some past repair. The mislocation would have caused the car to crab badly. The front right stub axle was also virtually destroyed and looked as if it was on fire. Must have been quite a handful.

Sunday, June 6, 2010
The naked frame. Still have found no significant rust. Have found a right frame rail that is full of
mouse nests. I've tried to vaccum as much as I can get to without alot of success. This might be a good reason to have the frame acid-dipped. the close-up shows some welding that is acually worse than mine on the left front motor mount. Needs to go away. This represents a big moment in the rebuild- a little frame repair, cleaning, paint, then I will start to put it all back together. That is more fun.

The rear axle seperate from the frame
. Axle is ENV-type as opposed to a Salisbury unit. All very early xk120's had this type. I am not sure why they changed to the Salisbury unit later. It might be that as a one piece casting as compared to the three piece of the Salisbury unit, that it was too expensive to manufacture. Both types are very durable. I will find out if this particular one is soon.
Subscribe to:
Posts (Atom)
